Installation Schlage Double Keyed Door Knob

Home » Hardware » Installation Schlage Double Keyed Door Knob

Double keyed door knob – Starting with mark 1:02 1/8 inch hole in the front of the door. According to the dimensions listed on the package. Place the center hole 2 3/8 inches from the edge of the door. And 5 1/2 inches from the center of the door handle. Fix 1:02 1/8 inch. Hold the edge plate. Mark the perimeter in the 3/16 inch deep. Attach a 1-inch hole saw bit to an electric drill and drill a hole in the middle of the edge plate until it meets the perpendicular hole you created latch assembly.

Posted on November 6, 2017 Hardware With 0 comments

Insert the bolt assembly into the edge of the door. Place a wooden block over the end and hammer assembly into the tree gently until it rests in place. Attach the edge plate with screws and a Philips screwdriver. Install double keyed door knob assembly into the hole on the outside of the door and tighten the screws. Fit thumb-turn or key-operated side of the locking device into the hole on the inside of the door and push it until it clicks into place. Tighten the screws.

12 Photos Gallery of: Installation Schlage Double Keyed Door Knob

RELATED TOPIC :  Cremone Hardware Replacing

Measure the distance between the bottom of the door and the bottom of the edge plate and placing the strike plate at the same distance on the door frame. Mark the perimeter of the strike plate and chisel out the wood as you did for the edge plate. Drilling a 1-inch diameter and 3/4 inch deep hole in the center of the strike plate. Fixing plate with screws and a Philips screwdriver. And the new double keyed door knob was done.

Tags: door knob assembly, how to install a schlage door handle